Automatic hydraulic press, small hydraulic press equipment, sesame oil hydraulic press machine equipment use precautions. Hydraulic press operation, material handling good embryos from the hopper into the pressing bore. In the next rotation of the pressing screw thread, and gradually feed end to the cake side direction forward. So that within each segment volume gradually narrow bore virgin; because of pressing screw thread continuously pressing the parison is pushed into the chamber, so that the front barrier pushed back to product pressure, compressed parison, the oil squeezed out. Before using a hydraulic press, the first should be ready all the aids and containers, check and adjust the belt tightness. Then start the motor, the machine idling about 15min, check the speed of pressing screw shaft. Usually the speed should be around 33dmin. Do you want to pay attention to when the idle gear box gear meshing and sound normal, whether the individual bearing parts and motor properly. When press idle, the motor current should be around 3A, such as the current is too high, should immediately stop checks, adjustments and then boot. Note: When you press the feed can not start too fast, otherwise the sudden increase pressure inside the chamber pressing, pressing screw shaft rotation does not move, causing blockage virgin bore, and even squeeze cage fracture, a major accident. So at the beginning of compression, the feed should be evenly slowly put into the hopper, the hydraulic press were running together. So press the temperature gradually increased, and even the risk of smoke (which is normal). At the beginning of the press virgin bore temperature is low, slowly twist the handle withered section studs, increasing the thickness of the cake, pressed into the billet while increasing moisture, temperature bore to be squeezed. Rose to about 90 ℃, normal operation after the press can be adjusted to the cake thickness 1.5-2.5mm, and tighten the nut tightened. Hydraulic press: http: //www.zzdfjx.com peanut oil press: http: //www.dongfeng668.com/ hydraulic oils machine: http: //www.zzdfjx.com refined equipment: http: // www.bafang818.com external power supply must be secure, the layout should be reasonably safe. Start the machine boost or oil extraction, the roof must be fully closed on. When the cake put on the roof is fully open. Equipment at work if unusual, please stop to check to see if the hydraulic system and the motor drive to fill the seats set screws loose, piping for leaks. When the end of the day, please clean the barrel residue inside and outside, to prevent clogging of diesel oil seam. Note that when you press the plunger end of the cake not raised too high, to prevent the hydraulic oil out. Adding the required grade of hydraulic oil, the timing of hydraulic oil filter, clean the tank, found that hydraulic oil reduction, should be supplemented. If it is found abnormal working pressure gauge, should promptly stop operation and notify the staff overhaul. Before the test machine users must press the regulations of the local power grid grounded the housing or zero line. Equipment in the course do not attempt to open the electrical cabinet or the fuel tank cap. Sesame oil machine: http: //www.bafang818.com